I am replacing the front wheel bearings on this motorhome chassis and I am not sure if these seals are correct. From watching countless videos on the subject, it seems like the inner seal should require some hammering to go into its resting place and hold the bearing in place. The seals that come up on every auto parts store and online for this model are the ones shown in the pictures and are the same ones that were installed there before, however I am not confident these weren't replaced before and because this is the part that comes up they just put it in anyway. The part fits the cavity just right but would fall off if I turned it over. Both left and right wheels are the same and have the same seal. Does this seem right? The seal fits around the base of the spindle just right. Its just not super tight in the hub which makes it harder to install as it wants to fall out while installing, but once in place its fine. Thanks for anyone's insight on this. I took some measurements in case that helps any. ~77.4mm is the diameter of the cavity and the seal specs say 76.3mm.