Going to hydraulic roller cam

[uhhhpooo]

send them over here we have a shortage of 88-94s around here to pick from

lol there is like 6 and they all are picked through

 

[99xcss4]

thats too bad

 

[uhhhpooo]

thats too bad

btw now the cost is 670 with oil and oil filter unless i can find a cheaper cam, even if it’s a factory vortec cam

 

[99xcss4]

this is one step above stock it is very mild used in ramjet 350 ht383 and ht383e I personally think it makes a good stock replacement and I think it should have been the stock cam https://www.summitracing.com/parts/nal-14097395

 

[uhhhpooo]

this is one step above stock it is very mild used in ramjet 350 ht383 and ht383e I personally think it makes a good stock replacement and I think it should have been the stock cam https://www.summitracing.com/parts/nal-14097395

i was told you need a tunned chip for it

 

[99xcss4]

you might put one in a 350 vortec that was 40 over bore with roller tip rockers shorty headers on the sock tune ran fine think it would have ran better with a tune do not know if it would be the same for you since you are tbi

 

[uhhhpooo]

you might put one in a 350 vortec that was 40 over bore with roller tip rockers shorty headers on the sock tune ran fine think it would have ran better with a tune do not know if it would be the same for you since you are tbi

has to much lift i am pretty sure

 

[99xcss4]

has to much lift i am pretty sure

I do not think so it is just under the limit for vortec heads with out mods tbi heads do not have that problem

 

[uhhhpooo]

I do not think so it is just under the limit for vortec heads with out mods tbi heads do not have that problem

not sure, @Schurkey do you know if it work without getting a tune, form the reviews some say it does but to really get benefits out of it get a tune but that’s every cam

 

[Schurkey]

I'm not the guy to ask about computer tunes.