Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Did they do a special surface finish for MLS gasket?I documented the work on the cylinder heads pretty well earlier in the thread. Summit/Dart Iron Eagle with 2.02/1.60 stainless valves, Cometic MLS .040 head gaskets, ARP head bolts.
You must be registered for see images attach
Good question, I don’t think so. I had the block decked and the heads are brand new and checked out flat when I was working on them. I’ve used that combo on my last couple of builds without issue.Did they do a special surface finish for MLS gasket?
Hmm. I dont have any first hand experience, I’ve just had a couple machine shops ask if I was using MLS because it was a couple extra steps? It’s probably just a much finer finishing pass.Good question, I don’t think so. I had the block decked and the heads are brand new and checked out flat when I was working on them. I’ve used that combo on my last couple of builds without issue.
You must be registered for see images attach
You must be registered for see images attach
I’ll have to ask my machinist.Hmm. I dont have any first hand experience, I’ve just had a couple machine shops ask if I was using MLS because it was a couple extra steps? It’s probably just a much finer finishing pass.