Texvet
OBS Enthusiast
1992 SCLB, 5.7 During my intake manifold gasket replacement project. The quick disconnect broke off. I replaced the quick connect fitting with a straight 3/4 in hose nipple.
My question is: The replacement heater hose is not formed. It is looped from the manifold to the heater core inlet. As a result, the new hose is higher than the inlet on the coolant recovery tank.
Will that create a problem with the recovery tank working correctly or cause an air pocket?
I hope this makes sense.
My question is: The replacement heater hose is not formed. It is looped from the manifold to the heater core inlet. As a result, the new hose is higher than the inlet on the coolant recovery tank.
Will that create a problem with the recovery tank working correctly or cause an air pocket?
I hope this makes sense.
Last edited: