From the looks of the
Photos I've Shown One would assume the points I placed the finder is accurate , No I don't have the drive shaft out , No I didn't place the tool at the end directly on the (machined) edge of the yoke where the caps seat.. . But it's read from a flat spot on the yoke that angles the same way the tool is a 2"x2" squared reader so it fits spots , unless I absolutely have to remove drive shaft
Photos I've Shown One would assume the points I placed the finder is accurate , No I don't have the drive shaft out , No I didn't place the tool at the end directly on the (machined) edge of the yoke where the caps seat.. . But it's read from a flat spot on the yoke that angles the same way the tool is a 2"x2" squared reader so it fits spots , unless I absolutely have to remove drive shaft
Last edited: