Can some sharp eye identify these cables?

Nad_Yvalhosert said:

They look suspiciously like the plugs on the encoder motor (aka the transfer case shifter) and the t-case position sensor, which sends power to the front axle actuator.

The giant clamp suggests it piggy-backs the round multi pin transmission harness. The general harness would contain the VSS breakout plug, and have enough length for the t-case mounted sensor on a 4x4 equipped vehicle, but would need additional power/ground and position sensor plugs for the NV243 case.

Click to expand...

Nad_Yvalhosert said:

No, too many pins for the downstream HO2S.

Click to expand...

Kevmore007 said:

Two sensors on one plug.

Click to expand...

Caman96 said:

I posted a picture earlier of your downstream o2 sensors. This picture is the upstream o2 sensors. The picture of the plug, in your hand,
is not for o2 sensors.

You must be registered for see images attach

Click to expand...

Kevmore007 said:

I have two that look like that, and two that have the square plug. The two with the square plug are tied together into a 6 pin plug that is in my hand.

Click to expand...

Kevmore007 said:

I have two that look like that, and two that have the square plug.

Click to expand...