Salty K1500
OBS Enthusiast
Pulled out the driveshaft to replace the u-joints. The one that goes to slip yoke was easy. The one that goes to the axle refused to come out. Both of the caps got stuck in the driveshaft. One of the shaft's yoke ears was quite beat up, might have been a contributing factor there. Pressing on the u-joint did nothing to move it either. I then tried cutting the u joint and wasn't paying attention and hit the yoke with the cutoff wheel. Between the cut and the damage already done to it, I decided to just buy a whole new driveshaft. Don't know if the damage to the old one was sufficient to cause problems, but I'm not trying to find out. At least the new shaft will look great with all the other new stuff under there.