Slipping trans after rebuild.

BradHanks15 · May 28, 2024

tayto said:
make sure you are checking end play with the input shaft pointing to the sky. do not check it with the transmission laying on the bench. also make sure the output shaft isnt resting on the ground either

Thanks. Was definitely the issue.

BradHanks15 · May 28, 2024

NickTransmissions said:
So with the transmission upright in the fixture, the output shaft was making contact with your workbench?

Id shim it to .020 but you're technically in spec so your call..

@NickTransmissions yes it was. I’ll go ahead and do that. I appreciate it.

BradHanks15 · Jun 13, 2024

@NickTransmissions got the trans back in finally. Everything seems to be working well. Pressures are good. Only thing is it won’t shift into 2nd unless you let off the throttle. On my scan tool it’s showing 2nd is being commanded but won’t shift until you let off the throttle a bit. Everything else is good. It did have a tb code and it has miss as well. Not sure if that’s affecting it. But I should be resolving the miss soon and I’ll retest. Also will try commanding it with the scan tool. Will also shift into 2nd manually.

Slipping trans after rebuild.

BradHanks15

OBS Enthusiast

BradHanks15

OBS Enthusiast

BradHanks15

OBS Enthusiast

Similar threads

Latest posts

Staff online

Members online

Forum statistics

Share this page