Confirmed brake bleeding scan tools

[Erik the Awful]

Aluminum RWAL ... "1) No Special bleeding procedure is required for this ABS system. Factory recommends bleeding r-rear first, then l-rear, r-front & l-front."

Can I get a second point of verification on this?

 

[AbelTwo]

I looked in my own service manual for my 1994 K1500, and @Schurkey was correct, above. Despite what my Solus Pro told me about not needing a scan tool to bleed the RWAL system in my truck, per my previous post, the service manual does call for bleeding the RWAL ABS with a Tech 1 scanner:

You must be registered for see images attach

I was too eager to accept the advice of my new (to me) Solus Pro. I shoulda' known better.

 

[Erik the Awful]

Current state of knowledge:

You must be registered for see images attach

 

[Caman96]

I only see one confirmation of the Foxwell NT630 for a 1999. Even the Autel noted a difference for 96-97 to a
98-99.

 

[Erik the Awful]

So, do I need to break out a difference between the 96-97 and 98-99 EBC310 system?

 

[Caman96]

I messaged a Seller for the Foxwell NT630 that requested my VIN(1996). They confirmed it does not support ABS bleed.

 

[Erik the Awful]

You must be registered for see images attach

Is this correct?

 

[Caman96]

I would say so. @Orpedcrow did you confirm the Autel wouldn’t support 97, but would 98+? I’m sure that would mean 88-97 for NO.

 

[Orpedcrow]

I would say so. @Orpedcrow did you confirm the Autel wouldn’t support 97, but would 98+? I’m sure that would mean 88-97 for NO.

That’s correct. NO for 97 down and YES for 98 up.

 

[Schurkey]

My Snappy 6.2 and 8.2 software would not bleed my '97 K2500.

But I never tried 'em on a '98-newer EBC310.

They WOULD auto-bleed my 2003 Trailblazer, which uses an EBC325 (?)

So--maybe--the 6.2 and 8.2 will work in '98-newer. I don't know, and I don't have a '98-newer EBC310 to check 'em with.