1990 K2500 Silverado, 4WD, Extended Cab, Short Bed, 350 5.7 - VIN K, Lower Control Arms (A-Arms)

[slik50]

1990 K2500 Silverado, Extended Cab, Short Bed, 350 5.7 - VIN K

I have a 1990 K2500 4WD, Silverado with the specs above but have not been successful locating the lower a arms / control arms for my application.

Does anyone have a cross reference for GM part #s 12380413 and 12380414?
Might anyone have a cross reference to other part numbers on the net?

Thanks!

 

[Caman96]

They are discontinued and no aftermarket available. Either install new bushings and ball joints in yours or find another set and replace same parts.

 

[slik50]

They are discontinued and no aftermarket available. Either install new bushings and ball joints in yours or find another set and replace same parts.

Any thoughts on where I may be able to find a L and R lower? Is there a good truck junkyard somewhere everyone reaches out to? Not much luck with local or google/internet searching thus far. Thx.

 

[Caman96]

Car-Part.com - Used Auto Parts Market

www.car-part.com

Enter your information and you should find many choices.

 

[Schurkey]

The arm cost isn't bad, but shipping will be hatefully expensive.

What's wrong with the arms you have?

 

[slik50]

The arm cost isn't bad, but shipping will be hatefully expensive.

What's wrong with the arms you have?

They are pretty rusted and Truck shop did not want to change out the bushings on these w/o knowing if another arm is avl.

 

[Caman96]

They are pretty rusted and Truck shop did not want to change out the bushings on these w/o knowing if another arm is avl.

Post a picture of them.

 

[slik50]

Post a picture of them.

I will once I get it back from shop either today or tomorrow. It's 1 hr away getting lift kit installed.

 

[Caman96]

Surface rust is fine. If rotted through, no good.

 

[slik50]

Surface rust is fine. If rotted through, no good.

Right! I'll be talking with the shop more bit later today but they stated they could change everything but the lower a arms /bushings/joint not knowing if it could go back together.