Philgoines
Newbie
Hello, new here and needing help. Thanks in advance. This may be long but here it is.
1996 k1500 5.7, crank no start
Was running great then died
Engine has about 5k on it new parts with install. Distributor, coil, ignition control module, plugs, wires, cam, crank sensors, coolant temp sensor, injectors, fuel pump and filter.
What I have checked.
Voltage and ground to all pig tails on the truck. This is with key off. All are good except air idle control. It has no ground. Cam sensor has two wires that are grounded. Fuel psi is above 55 and holds. Compression is 195. I have spark and fuel. I checked tpm in live data during crank and see 0. I am needing a pin out to ecm to very that the wires are good from crank sensor to ecm. I can read data so I feel the ecm is good. No codes in the truck. I did verify timing, I can watch reluctantly wheel turn and chain also. All valves and rockers intact. I think I am on the right track. Any suggestions would help.
1996 k1500 5.7, crank no start
Was running great then died
Engine has about 5k on it new parts with install. Distributor, coil, ignition control module, plugs, wires, cam, crank sensors, coolant temp sensor, injectors, fuel pump and filter.
What I have checked.
Voltage and ground to all pig tails on the truck. This is with key off. All are good except air idle control. It has no ground. Cam sensor has two wires that are grounded. Fuel psi is above 55 and holds. Compression is 195. I have spark and fuel. I checked tpm in live data during crank and see 0. I am needing a pin out to ecm to very that the wires are good from crank sensor to ecm. I can read data so I feel the ecm is good. No codes in the truck. I did verify timing, I can watch reluctantly wheel turn and chain also. All valves and rockers intact. I think I am on the right track. Any suggestions would help.