I'm wondering if it would be possible to to a swap the motor from an older pre OBD2 truck into a newer OBD2 truck. The motor is from a '95 TBI and is a 5.7L small block, I want to try upgrading it and putting it into a '98 body with a 4L60-E (also going to be upgraded) transmission. I want to know if there was anything that I should watch out for, like if I would have to change any of the wires and computers, fuel routing, if I'm able to change it from TBI to Port-injected, and to put some other upgrades into the motor. My goal is just to make a fun mud bogger but I wanna make sure that I don't screw myself over and have it done properly. Any help and thoughts appreciated! Also I'm sorry if this is the wrong place to post this.