Cadillacmak's latest activity
-
Cadillacmak replied to the thread Vortec to Carb swap.https://www.gmt400.com/threads/carb-swapped-%E2%80%9897-vortec-success.62757/ Check this out -
In almost there too. My 81 always gets me where I need to go. Nothing to break, nothing to fix. Simple
-
Haha..screw TBI and the meriad of sensors..tired of trying to fix OBD codes
-
These controllers are expensive. You could always go manual valvebody and use a vac-mod setup to control line pressure. peace Hog
-
You can get a tci stand alone computer to operate your transmission
-
Down for the carb swap. I was about to do it myself. Hei distributor. Special intake. Fuel pressure regulator. Holly i believe is the...
-
Any up-dates on this?
-
MAy be more better to 5.3l ls swap pcm swap , efilive to reprogram . 5.3l with cam can do 400 hp easy a/c bracket intergrating gauges...
-
I've heard I can run the tranny off the tps hooked back into the hei. We are still planning on this swap but researching our hearts out...
-
Seems to me it'd be cheaper to reflash for more performance and you'd be asspain ahead.
-
id like to know as well. Seen some run a special trans computer and certain ones be able to rig a few sensor up to control the trans off...
-
I'm doing the vortec to carb swap 600 cfm 4 barrel carb hei distributor. Who has done this swap and kept the factory controlled trans...
-
Cadillacmak reacted to Cuckfield's post in the thread [Solved] Hvac fan not turning on at all (1995 chevrolet k2500 7.4 tbi) with
Like.
1995 chevrolet k2500 7.4l Hello, my hvac one day just completely stopped working. Replaced relay, resistor, and blower motor, stopping... -
Cadillacmak reacted to Cuckfield's post in the thread [Solved] Hvac fan not turning on at all (1995 chevrolet k2500 7.4 tbi) with Like.
No blower fan in any position. Checked fuses, all look fine. Ac is dead, but that's a different hoss. My ac system has a leak and the...
-
Cadillacmak reacted to Cuckfield's post in the thread [Solved] Hvac fan not turning on at all (1995 chevrolet k2500 7.4 tbi) with Like.
Evidently I'm operating on bad info. That aside, any way I can test my hvac control switches? Pulled the switch module out and the...
