Recent content by MANIAC

M
95 Chevy Silverado 5.7l tbi rough start, idle, acts like it's flooding then dies.

Hey guys I have a 95 k2500 suburban 350 I recently rebuilt it and replaced everything top/bottom end and yes I do mean everything but the O2 sensor which i already checked and it was good, and the purge valve or whatever the sensor the EGR plugs into is called I have had a hard time getting the...
- MANIAC
- Post #8
- May 19, 2024
- Forum: Engine Performance + Maintenance
M
5.7L TBI stalling and low idle help

Fuel is less than two months old, timing when I can get it to run on its own and this is only with the timing advance wire unplugged is at 16° BEFORE TDC I don't currently have a way to test fuel pressure however I think it's running too lean since it's idling so low I did rebuild the throttle...
- MANIAC
- Post #49
- May 10, 2024
- Forum: Engine Performance + Maintenance
M
5.7L TBI stalling and low idle help

Ok so when I got the truck I was originally told it had nothing done to the fuel system it has (MAXSPEEDING link bar hyd roller lifters) plus it's an OBD1 the only code it's throwing is code 43 which is a knock sensor code and the only sensors that aren't brand new are the o2 and the purge valve...
- MANIAC
- Post #45
- May 10, 2024
- Forum: Engine Performance + Maintenance
M
5.7L TBI stalling and low idle help

So I have a similar issue that I've been trying to chase for what seem like a while but here's what I got 1995 K2500 suburban with the 5.7 originally, When I got the truck it was built to have 393 cubic inches of displacement and it's a stroker motor I rebuilt the entire thing from the block...
- MANIAC
- Post #43
- May 9, 2024
- Forum: Engine Performance + Maintenance